TDGJ3 Accucraft Gas Jet #3 0.15mm
#3 Jets are recommended for the Accucraft B4, Dora and other similar small boiler locomotives.
Accucraft Gas Jets
All jets are high quality custom machined to give you the option to tune your burner to suit your particular needs. Each one is cleaned and flow tested. As with all jets, a small amount of liquid teflon is needed on the outer threads of the jet when installing.
#5 Jets are recommended for the medium boiler locomotives such as 0-4-0 and 2-6-0 variants. Can also be used on twin flue locomotives needing a lower gas consumption.
#7 Jets are recommended for the large boiler locomotives both single and twin flue boilers that need a larger fuel rate.
Used to seal threads on any boiler and gas fittings. Safe up to 400 degrees
Also required sealant for use with the replacement gas valves (TD75, TD75, TD76) to apply to the new bushing threads when installing into the gas valve housing.
This is the replacement or add on check valve to add a handpump to a model that does not have one or to replace the failed check valve supplied with the model.
You either can plumb in a copper line or solder a Made quick disconnect to a M5 union nut for a direct quick disconnect option.
Accucraft replacement gas filler. Thread M5 x .05
This is a replacement valve built to the Ronson standard.
Preset safety valve threaded M5 for direct replacement. Also available is a M10 thread adapter for locos that do not already have the adapter from Accucraft.