TD77 Steam Valve Replacement
Fine point steam valve, reuses your existing knob or lever
Simply unscrew the orignal and screw in the new.
Universial for for all Accucraft locomotives, some require the shaft length to be trimmed.
Fine point steam valve, reuses your existing knob or lever
Simply unscrew the orignal and screw in the new.
Universial for for all Accucraft locomotives, some require the shaft length to be trimmed.
As used on the Accucraft Hunslet/Ragleth and other similar floor mounted valves.
*Does not fit the 2nd batch Hunslet due to production changes*
Valve fits locomotives with the 17mm spindle length measured from the bottom of the thread to the tip of the needle. Anything less than 17mm works. Anything over 17mm will not.
Fine point gas valve for tender mounted gas tanks and long handle cab tanks. Uses your existing knob.
Some tenders and will require the short valve, please look to see if your knob is more than 1/2" - 5/8" from the valve body. Others may require the length to be trimmed to match the orignal length.
Fine point gas valve for in short cab mounted tanks. Has a L shaped wire for a handle.
Revised spindle length to accomodate both newer and earlier locomotives.
Fine point gas valve for short length in cab mounted tanks. Uses your existing knob.
Note some very early locomotives require a special length spindle, if you have a early UK loco contact me.
For use with all gas valve upgrades along with any plumbing and boiler fittings. Good to 400 degrees